Alpharetta, GA Heating & Cooling

Made a service visit to one of our regular clients in Alpharetta's tech corridor. Their Lennox EL296UH090XV36C furnace showed pressure switch error. Inspected venting system and found partially collapsed flex duct. Replaced damaged section and verified -0.88 inches WC draft pressure.

On location in Alpharetta resolving a no-heat complaint on a Trane S9V2-VS furnace. Found corroded flame sensor and weak hot surface igniter. Replaced both components (part #IGN00141 and FLM00142). Measured 3.8 microamp flame signal and verified proper ignition sequence.

I arrived at a home in the Avalon neighborhood of Alpharetta, GA, for a heater repair job. The homeowner reported that the furnace was running but not producing enough heat. After inspecting the system, I found a clogged air filter and a faulty limit switch. I replaced the switch, installed a clean filter, and tested the system to ensure proper heating. The customer was pleased with the quick fix and noticeable improvement in warmth. Contact us for expert heater repair services!

In Alpharetta, GA, I repaired a Trane XR95 furnace that was short-cycling. After inspecting the flame sensor, I cleaned off the buildup and tested the system. I also checked the blower motor for proper function. Once done, the furnace ran smoothly without any interruptions.

Today, I performed routine maintenance on a Carrier Infinity heat pump in Alpharetta, GA. This involved cleaning the outdoor coils, checking refrigerant levels, and inspecting the reversing valve. I tightened electrical connections and ensured the defrost cycle was functioning properly. Everything was operating efficiently after the service.

I completed a furnace tune-up for a homeowner in Alpharetta, GA. I replaced a clogged air filter, cleaned the burners, and tested the ignition system. The furnace’s efficiency improved significantly, and I ensured the thermostat was calibrated correctly for consistent temperature control.

In Alpharetta, GA, I repaired a Lennox ML296V furnace that was blowing cold air. Upon inspection, I found a faulty ignitor. I replaced it with a new OEM part, tested the ignition sequence, and verified that the heat exchanger was warming properly. The system was back to delivering warm air quickly.

I handled a heat pump repair for a client in Alpharetta, GA. The unit wasn’t switching to heating mode due to a malfunctioning reversing valve. I replaced the valve, checked refrigerant levels, and tested the heat pump. Everything was functioning correctly by the time I left.

In Alpharetta, GA, I completed a furnace maintenance task for a homeowner. I replaced the air filter, cleaned the flame sensor, and checked the gas pressure. After inspecting the heat exchanger, I confirmed everything was in good condition, ensuring reliable heating throughout the cold winter days.

I replaced a malfunctioning thermostat for a customer in Alpharetta, GA. The existing unit wasn’t properly controlling the heat pump, causing erratic temperatures. I installed a new programmable thermostat, calibrated it to match the system, and tested its operation. The customer now has accurate and consistent temperature control.

I worked on a Carrier Performance heat pump in Alpharetta, GA that wasn’t heating properly. Upon inspection, I found low refrigerant levels due to a small leak in the evaporator coil. I sealed the leak, recharged the refrigerant, and tested the system. The heat pump was back to full functionality.

I replaced a worn-out blower motor on a Lennox Elite furnace for a client in Alpharetta, GA. The old motor had started making loud noises and eventually stopped working. I installed a new motor, balanced the blower wheel, and tested airflow. After checking the system, everything was running smoothly and providing consistent heat throughout the home.

installed full systems 15seer trane

Alpharetta heating emergency response. Diagnosed intermittent blower motor failure. Replaced ECM motor with high-efficiency model. Checked belt alignment and tension. Conducted electrical resistance tests on motor windings. Verified proper airflow and system operation.

In Alpharetta, GA, I repaired a Rheem RP15 heat pump experiencing refrigerant leaks. After locating the issue in the evaporator coil, I sealed the leak, recharged the system with R-410A refrigerant, and checked superheat and subcooling levels to verify system performance.

I repaired a Rheem Prestige Series gas furnace in Alpharetta this morning, that had a malfunctioning igniter. I replaced the faulty igniter with a compatible OEM part and inspected the gas valve and flame sensor. The furnace was tested and restored to safe operation.

No cool service call performed by Derrick in Alpharetta, GA.

No cool service call performed by Derrick in Milton, GA.

Heber completed an AC tune up per Service Agreement on a Trane unit for a customer in Alpharetta, GA.

Heber competed an AC tune up on a Lennox unit for a customer in Alpharetta, GA.

Marcio and Andy installed a 2.5 ton Lennox evaporator coil for the air handler for a customer in Alpharetta, GA. Added 8 pounds of 410A refrigerant and unclogged the drain line. Unit is working upon completion.

Chris performed an AC tune up on a Lennox unit per Service Agreement for a customer in Alpharetta, GA.

Tech performed an AC tune up on a Trane system for a Service Agreement customer in Alpharetta, GA.

Performed a no cool service call in Alpharetta, GA. Customer is very happy to have cool air.

Derrick completed an AC tune up on a Goodman unit for a Service Agreement customer in Alpharetta, GA.