Woodstock, GA – HVAC Service

Heating System Diagnostics: When inspecting a heat pump that was failing to maintain temperature, I found restricted airflow caused by a clogged air filter and a partially obstructed return duct. I replaced the filter, cleared the obstruction, checked refrigerant pressures, and verified proper heating performance.

Heating System Repair Service: While troubleshooting short cycling, I determined a faulty high-limit switch was causing premature shutdowns due to inaccurate temperature readings. I replaced the switch, adjusted airflow where needed, and confirmed normal heating cycles and safe operation.

Heating System Preventative Maintenance: During a seasonal furnace tune-up, I found dust accumulation inside the burner compartment and debris restricting airflow. I cleaned internal components, inspected electrical connections, tested safety controls, and verified improved system efficiency.

Heating System Service: Upon investigating uneven heating and restricted airflow, I discovered worn blower motor bearings causing overheating and reduced performance. I replaced the blower motor, adjusted fan speed settings, balanced airflow at the registers, and confirmed even heat distribution throughout the home.

Heating System Repairs: When diagnosing weak heat output, I identified a failing blower motor capacitor that was preventing proper airflow across the heat exchanger. I replaced the capacitor, tested motor operation, inspected wiring connections, and verified normal heat delivery.

AC Repair Service: During an evaluation of poor cooling performance, I discovered a refrigerant leak at the evaporator coil connection causing low system charge. I repaired the leaking fitting, pressure-tested the system, evacuated moisture from the refrigerant lines, recharged the system to manufacturer specifications, and confirmed proper temperature split and stable cooling operation.

Indoor Air Quality Service: While servicing the home’s air purification unit, I found the filter heavily clogged with dust, pet hair, and debris. I replaced the filter, cleaned the cabinet interior, and tested the unit to ensure proper airflow and improved filtration of indoor contaminants.

HVAC Repair: A homeowner complained of weak airflow and unusual noises from the HVAC system. Inspection showed a worn and slipping blower belt that was preventing the fan from operating at full speed. I replaced the belt, aligned the pulleys, and tested airflow. The system now delivers strong, quiet, and efficient circulation.

HVAC Repair: The homeowner noticed reduced airflow and poor cooling throughout the house. Inspection revealed a severely clogged air filter restricting air movement and causing the system to overheat. I replaced the filter, cleaned the return area, and verified proper airflow. Once serviced, the HVAC system delivered steady, efficient comfort again.

Indoor Air Purification System Installation: The homeowner contacted us with concerns about indoor air quality. After a consultation to assess their needs and select the appropriate system, we scheduled the installation. Installed a UV light air purification system within the HVAC ductwork, securely mounting it near the air handler and connecting it to the system’s power supply. Tested the system to ensure safe and effective operation. The UV light now helps reduce airborne pathogens, allergens, and microbes, improving overall air quality and creating a healthier home environment.

Heating System Repair: Responded to a call that a heat pump was struggling to heat the home. Diagnosed ice buildup on the outdoor coil caused by a blocked drain and dirty coil fins. Cleaned the coil, cleared the drain line, and verified defrost cycle operation. The heat pump now heats efficiently and maintains consistent indoor temperatures.

installed trane full systems drain pan w/ float switch + in line switch

Upgraded 2.5-ton R-22 system to R-410A model. Pulled deep vacuum to 500 microns, verified proper charge, and confirmed operation matched home’s cooling load requirements.

Service call for warm-air complaint on Carrier Comfort Series unit. Evaporator coil was clogged with debris. Completed deep cleaning to restore optimal heat transfer.

Removed aging 3-ton system with compressor failures. Installed high-efficiency replacement, balanced airflow in duct system, and programmed thermostat for comfort and efficiency.

Performed an AC tune-up today on a Carrier system, inspecting coils, checking refrigerant levels, and cleaning the condensate drain. The system was operating with low airflow, which we traced to a clogged filter and partially blocked return vent. After resolving the issue, airflow and cooling performance significantly improved.

Performed seasonal AC tune-ups on both Rheem and Trane systems at a residential property. For the Rheem unit, inspected the contactor, checked refrigerant pressures, and cleaned the outdoor coil. The Trane system required a capacitor test, thermostat calibration, and filter replacement. Both units were tested for temperature split and are now running efficiently ahead of peak summer heat.

Replaced a clogged TXV on a heat pump system. I recovered the refrigerant, removed the faulty valve, and brazed in a new OEM TXV. After evacuation and recharge, I tested subcooling and superheat to confirm proper metering and efficiency.

Responded to a no-cool call and found a low-pressure lockout. Checked the system and discovered a refrigerant leak at the Schrader valve. Replaced the valve core, pressure-tested with nitrogen, pulled a vacuum, and recharged the system with 5 lbs of R-410A.

Upgraded a customer’s HVAC system with a Guardian air purifier. I mounted the unit in the supply plenum and connected it to the blower interlock. The customer now benefits from reduced airborne bacteria, mold spores, and VOCs.

Installed a Guardian air purifier into a customer's HVAC return. I wired it directly into the system’s 24V transformer and secured the housing to avoid vibration. The unit now treats all circulated air with UV-C light and a catalytic reaction to neutralize VOCs and microbes.

Completed a furnace repair for a family in the Woodstock area. Their York TG9S080B12MP11C furnace wouldn't start. Multimeter testing revealed failed transformer providing only 18V instead of 24V. Installed new transformer (part #S1-02435762000) and confirmed proper voltage across control board.

Our Woodstock customers called about an American Standard S9V2B080U4PSAB furnace experiencing short cycling. Multimeter testing revealed failing circuit board causing erratic temperature readings. Replaced control board with OEM part #BRD2101. Verified proper operation through multiple heating cycles.

Woodstock heat pump system evaluation and repair. Conducted full electrical system diagnostics. Measured compressor amp draw and winding resistance. Replaced worn contactor and capacitor. Cleaned outdoor condensing unit coils. Verified system superheat at 12 degrees Fahrenheit.

I replaced a malfunctioning Honeywell thermostat with a SmartThermostat in a Woodstock, GA home. The job included disconnecting the old thermostat, reconfiguring the wiring, and setting up Wi-Fi connectivity for remote access. The homeowner's HVAC system now runs smoothly with advanced control features.